Warning Cookies are used on this site to provide the best user experience. If you continue, we assume that you agree to receive cookies from this site. OK

Arduino Usb-to-Serial Converter - A000107

A000107
02-00010311
This board converts a USB connection into a 5 volt Serial TX and RX that you can connect straight to the Arduino Mini or other microcontrollers, allowing them to talk to the computer.
12.50
Out of Stock

We (GRobotronics) will add your email address to a special mailing list for this product. Once the product is in stock, you’ll get an email about it automatically, and your email address will be removed from the product’s mailing list.

The data will be visible to some members of our staff. If you’d like to have your personal data removed, send an email to dpo@grobotronics.com.

If you believe that your personal data has been misused, you have the right to lodge a complaint with a supervisory authority. We’re obliged by EU General Data Protection Regulation to let you know about this right; we don’t actually intend to misuse your data.

Add to wish list
Διαθεσιμότητα Καταστήματος Αθήνας
Out of stock

This board converts a USB connection into a 5 volt Serial TX and RX that you can connect straight to the Arduino Mini or other microcontrollers, allowing them to talk to the computer. It features an Atmega16U2 programmed as a USB-to-serial converter, the same chip found on the Arduino Uno. The '16U2 firmware uses the standard USB COM drivers, and no external driver is needed. However, on Windows, a .inf file is required.

The USB Serial Adapter has an onboard micro-USB connector and 5 pins including RX (for receiving data from the computer) and TX (for transmitting data). 5V, Ground and a Reset pin are also exposed.

Status lights include power, RX and TX activity.

The adapter can easily connect to the Arduino Mini.

An onboard polyfuse limits the current to 500mA and protects the host computer from short circuits.

 

The ATmega16U2 firmware source code is available. The ATmega16U2 is loaded with a DFU bootloader, refer to the DFU mode section. You can then use Atmel's FLIP software (Windows) or the DFU programmer (Mac OS X and Linux) to load a new firmware if required. You can use the ISP header with an external programmer (overwriting the DFU bootloader). See this user-contributed tutorial for more information.

Documents:

MPN:
A000107
Made in:
Italy

No posts found

Write a review