ΔΩΡΕΑΝ ΜΕΤΑΦΟΡΙΚΑ για παραγγελίες άνω των 85.00 έως 2kg

Carbide Square End Mill - 1/8" Shaft - 0.8mm Diameter

από OEM
The cutting part is made from tungsten carbide and are suitable for circuit board cutting and probably some other soft metals and other materials. Each...
09-00002075
Ογκομετρικό βάρος: 0kg
Κατασκευαστής: OEM
Χώρα Προέλευσης: Κίνα
Κατόπιν Παραγγελίας
Παράδοση έως 30 ημέρες
Χωρίς απόθεμα στο φυσικό κατάστημα
4.90
Χωρίς ΦΠΑ 3.95
+

ΠΕΡΙΓΡΑΦΗ

The cutting part is made from tungsten carbide and are suitable for circuit board cutting and probably some other soft metals and other materials. Each endmill has a high hardness, wear resistance and strength and they're also super sharp which helps when cutting thru PCBs. These mill bits have a fairly long flute, about 5mm. While this is a bit longer than we are used to, we have found that the bits work quite well and are low cost enough to replace if they break. Note that even carbide bits will dull eventually when cutting PCBs, we found we could cut for about 5 hours on each bit before we find they need replacing.

This product comes with one 0.5mm carbide end mill in a protective plastic case.

Specifications:

  • Total length: 38mm
  • 1/8" Shank
  • Diameter: 0.8mm

ΧΑΡΑΚΤΗΡΙΣΤΙΚΑ

Είδος Εργαλείου:
  • Τρυπάνι
Κατασκευαστής
:
OEM
Μικτό Βάρος:
0.001kg
Χώρα Προέλευσης:
Κίνα
BoxNow Product