FREE SHIPPING for orders over 85.00

DC Dual Motor Driver 30V 4A V2

The DC Dual Motor Driver 30V 4A V2 allows to indipendently drive two DC motors, controlling both velocity and direction.

08-00010042
Company: Microbot
Made in: Italy
In Stock
Ships in 24 Hours
No stock in retail store
19.90
Without VAT 16.05
+
WISHLIST COMPARE

DESCRIPTION

The DC Dual Motor Driver 30V 4A V2 allows to indipendently drive two DC motors, controlling both velocity and direction.

It is based on the famous integrated circuit L298, producted by STMicroelectronics; the L298 is an integrated monolithic circuit in a PowerSO20 package. It is a high voltage, high current dual fullbridge driver designed to accept standard TTL logic levels and drive inductive loads such as relays,solenoids, DC and stepping motors.

The minimum supply voltage allowed is 7V, so you can use also two-cell LiPo batteries (7.4V)that grant small dimensions and low weight characteristics. The maximum supply voltage supported by this board is 30V.

To enable or disable each channel independently of the input signals there are provided two enable inputs (E1, E2) positioned on the front of the board; motor velocity regulation is obtained applying to these pins a PWM signal with a 20KHz max. frequency.

This board also provides direction LED indicators for both channels; this is very usefull during setup stage to verify the firmware behaviour (also without appling a real motor to the output).

SPECIFICATIONS

Driver Type:
  • DC Motor
Max. Current per Channel:
2A

EXTRA SPECIFICATIONS

  • Supply voltage: 7 - 30V
  • Supply current (logic): 24mA typ. (36mA max.)
  • Output current: 4A (2A for each channel)
  • Data I/O voltage: TTL standard
  • Operating temperature    -25 - 130°C

Dimensions

  • 37 x 36 x 13mm (connector included)
  • Weight: 12.5g / 0.44oz