ΔΩΡΕΑΝ ΜΕΤΑΦΟΡΙΚΑ για παραγγελίες άνω των 85.00 έως 2kg

Microwave Radar Sensor - RCWL-0516

από OEM
Αυτός ο αισθητήρας έχει σχεδιαστεί ως εναλλακτική λύση για τους κοινούς αισθητήρες κίνησης PIR που χρησιμοποιούνται ευρέως σε συναγερμούς και φώτα ασφαλείας. Όπως και ο αισθητήρας PIR, αυτός ο αισθητήρας ανιχνεύει επίσης μόνο κινήσεις εντός του εύρους ανίχνευσής του. Αλλά αντί να ανιχνεύει την ακτινοβολία του μαύρου σώματος από ένα κινούμενο άτομο, αυτός ο αισθητήρας χρησιμοποιεί μια τεχνική "ραντάρ μικροκυμάτων Doppler" για να ανιχνεύσει κινούμενα αντικείμενα.
19-00018968
Ογκομετρικό βάρος: 0kg
Εγγύηση: Ως εξάρτημα, δεν καλύπτεται
Κατασκευαστής: OEM
Χώρα Προέλευσης: Κίνα
Διαθέσιμο
Αποστολή σε 24 ώρες
Διαθέσιμο στο φυσικό κατάστημα
1.80
Χωρίς ΦΠΑ 1.45
+
Τιμές βάση ποσότητας (Λιανική - Χονδρική):
Ποσότητα 10+ 100+
Τιμή 1.44 1.26

ΠΕΡΙΓΡΑΦΗ

This sensor module has been designed as an alternative to the common PIR motion sensors widely used in burglar alarms and security lights. Like the PIR sensor, this sensor also detects only movements within its detection range. But instead of sniffing the black body radiation from a moving person, this sensor uses a “microwave Doppler radar” technique to detect moving objects.

The module has the characteristics of high sensitivity, high induction distance, high reliability, large induction angle, wide power supply voltage range, etc. it is widely used in various kinds of human body induction lighting and alarm and so on.

This mini doppler radar sensor module is equipped with supporting DC 4-28V wide voltage. This is a mini radar motion sensor module is equipped with RCWL-9196 chip based on the doppler microwave induction technology. It will automatically comtinuously output the high level TTL signel when there is motion. 360 degree no blind angle detection and maximum 7m sensoring distance with adjustable delay time and sensitivity.

It has a sensitivity range of ~7 meters. When triggered, its TTL-level output (OUT) pin will switch from LOW (0 V) to HIGH (3.3 V) for a finite time (2 to 3 s) before returning to its idle (LOW) state.

It is perfect for DIY microwave motion sensor light switch, human sensor toys, smart security devices, etc.

 

ΣΗΜΕΙΩΣΕΙΣ

  • The right ahead of induction side should’t place any metal to block.
  • The front/back side should reserve more than 1cm space Module and installation carrier

ΧΑΡΑΚΤΗΡΙΣΤΙΚΑ

Εγγύηση:
Ως εξάρτημα, δεν καλύπτεται
Κατασκευαστής
:
OEM
Μικτό Βάρος:
0.001kg
Χώρα Προέλευσης:
Κίνα
Τύπος Αισθητήρα:
  • Κίνησης
Τυπική Τάση Εισόδου:
  • 4VDC
  • 5VDC
  • 12VDC
  • 24VDC
Διασύνδεση:
  • Ψηφιακή

ΕΠΙΠΛΕΟΝ ΧΑΡΑΚΤΗΡΙΣΤΙΚΑ

  • Operating Voltage: 4-28V
  • Operating Current: 2.8mA (typical), 3mA (max)
  • Detection Distance: 5-9m
  • Transmitting Power: 20mW (typical), 30mW (max)
  • Output Voltage: 3.2-3.4V
  • Output Voltage Driving Capacity: 100mA
  • Trigger Way: repeat trigger
  • Output Control Low Level: 0V
  • Output Control High Level: 3.3V
  • Operating Temperature: -20~80 celsius
  • Storage Temperature: -40~100 celsius
  • Dimensions: 36x17.5x3mm


Adjustment Part Introduction:

  1. C-TM Adjust repeat trigger time,default trigger time is 2s;increasing capacitor’s capacity will make repeat trigger time longer;and actual counting trigger time can operate as below: Stick capacitor on C-TM,test 9196 3-pin frequency F,repeat trigger time T=(1/f)*32768
  2. R-GN Detection distance adjustment;connect with resistor and detection distance will become shorter;if not connect,detection distance is 7m;if connect with 1M ohm resistor,detection distance is 5m
  3. R-CDS Internal VCC parallel connect with internal 1M ohm resistor to CDS pin (that is 196 9-pin) by R-CDS ,CDS connects with photoresistor,you can close detection function at night

Pin Definition:

  • 3V3:3V3 power output
  • GND:ground
  • OUT:control output;when detect moving objects,it will output high level
  • VIN:input voltage,4-28V
  • CDS:enable control chip,lower than 0.7V,OUT will output low level all the time

ΔΥΝΑΤΟΤΗΤΕΣ

  • Equipped with RCWL-9196 chip supporting 4-28V wide voltage input, high level signal output when detecting the motion with active repeat trigger
  • 360 degree no blind angle detection with 5-7m deteciting distance, the detection not affected by the surroundings, better performance than the IR sensor
  • Support night detecting function turn on /off, adjustable repeat trigger time and detecting distance by add the SMD components to the corresponding pins
  • Working Voltage: DC 4-28V, Board Size: 35.9 X 17.3mm/1.41 X 0.68inch

ΑΡΧΕΙΑ