ServoBlock Kit - Hitec Standard (Hub Shaft)
Διαθεσιμότητα Καταστήματος Αθήνας
ServoBlocks increase a servo’s load-bearing capabilities by helping to isolate the lateral load from the servo spline and case. The extreme versatility of ServoBlocks allow users to create complex, extremely rigid, structures with ease using standard Hitec servos. The 1/2” aluminum hub shaft provides multiple mounting options using 6-32 screws. The robust 6061 T-6 aluminum framework acts as a servo
exoskeleton, greatly enhancing the mechanical loads the servo can withstand. Our new .770” hub pattern is repeated throughout the framework to allow endless attachment options. Compatible with standard size Hitec servos with a 24T spline. Kit comes unassembled, servo not included.
Actobotics is a robotics building system based around extruded aluminum channels, gears, precision shafts, and ball bearings. Thanks to the two standardized hole patterns, nearly all Actobotics components can be intuitively connected together. The wide range of components makes building complex electromechanical prototypes or finished projects a reality.
A1 Sub-micro Spline (15 teeth)
B1 Mini Spline (25 teeth)
HS-125MG, HS-56HB, HS-65HB.....many other mini servos.
C1 Standard Spline (24 teeth)
Any standard size Hitec servo. Even the HS-755HB, HS-755MG, HS-765HB and the HS-785HB servo use this standard size spline.
H25T Hitec Standard Spline (25 teeth)
HS-83XXTH and HSB-93XXTH series servos.
NOTE: This spline is the same as the Futaba 25T Standard Spline (3F).
D1 Heavy Duty Spline (15 teeth)
HS-805BB and HS-815BB servos
At this time, Futaba / Feetech manufactures servos with 4 different splines. When choosing components to attach to your servo, it is important to know what size of spline your servo uses. Below are the four various splines. If you have any questions as to what spline your servo has, please check the servo page or contact us via email or phone.
1F Spline (15 tooth)
Futaba servos such as the S3111, S3114 & S3154.
2F Spline (21 tooth)
Micro servos such as the S3153, S3107, S117 and similar have the 2F size spline.
3F Standard Spline (25 tooth)
Most standard size Futaba servos have the 3F spline.
4F Spline (25 tooth)
This spline is found on most Giant scale servos like the S3306 and the S9154.
- Hub Pattern - 0.77"
- Hub Shaft
- Hitec Standard Compatible
- Product Page (637110)