FREE SHIPPING for orders over 85.00

Servo Standard 17kg.cm Metal Gears with Analog Feedback (Feetech FB5118M)

by Feetech
It looks like a servo, it acts like a servo, but it's more than just a servo! We got a factory to custom-make these classic 'standard' sized hobby servos...
11-00012819
Company: Feetech
Part Number: FB5118M
Made in: China
Out of Stock
Product out of stock
Low stock in store
16.90
Without VAT 13.63

We (GRobotronics) will add your email address to a special mailing list for this product. Once the product is in stock, you’ll get an email about it automatically, and your email address will be removed from the product’s mailing list.

The data will be visible to some members of our staff. If you’d like to have your personal data removed, send an email to dpo@grobotronics.com.

If you believe that your personal data has been misused, you have the right to lodge a complaint with a supervisory authority. We’re obliged by EU General Data Protection Regulation to let you know about this right; we don’t actually intend to misuse your data.

Add to Cart
WISHLIST COMPARE

DESCRIPTION

It looks like a servo, it acts like a servo, but it's more than just a servo! We got a factory to custom-make these classic 'standard' sized hobby servos with a twist - the feedback (potentiometer wiper) line is brought out to a fourth white wire. You can read this wire with an analog input such as those on an Arduino, to get the servo's position. That information can be used in robotics to improve stability or even allow 'recording' of servo motion.

This is the standard size Metal Gear Digital Servo. This solid consumer grade servo is able to take in 7.4 volts and deliver 17kg.cm of maximum torque at 0.16sec/60°.

This is a simple servo for any project with accuracy in motion!

This high quality servo is perfect for your mechatronic needs and if you are looking to get into robotics, this is where to start.

The FΒ5118M servo comes standard with a 4-pin power and control cable (red=power, black=ground, white=data and yellow=feedback) and all hardware listed below.

SPECIFICATIONS

Gear Type:
Metal
Rotation:
270°
Servo Operation:
Digital
Servo Size :
Standard
Speed (6V):
0.20sec/60°
Torque (6V):
15kg.cm

EXTRA SPECIFICATIONS

  • Mechanical
    • Gear type: Steel Gear
    • Limit angle: No limit
    • Bearing: 2 Ball bearings
    • Horn gear spline: 25T(5.9mm)
    • Horn type: Plastic,POM
    • Case: Nylon & Fiberglass
    • Connector wire: 300mm ±5 mm(Black ,Red, Yellow and White)
    • Motor: Metal brush motor
    • Splash water resistance: NO
    • Size: 40x38.7x20.3mm
    • Weight: 65g
  • Electrical (Function of the Performance)
Operating Voltage Range 6V 7.4V
Idle current(at stopped) 5mA   7mA
No load speed 0.2sec/60° 0.16sec/60°
Runnig current(at no load) 130mA 150mA
Peak stall torque 15kg.cm 17.5kg.cm
Stall current 1500mA 1800mA