Copymaster3D Magnetic Build Surface 235x235 mm

Magnetic Build Surfaces from Copymaster3D are high quality, affordable build surfaces that are reliable time and time again.
With hundreds of build surfaces out there to choose from, this should be your go to choice.

Buy this Copymaster3D Magnetic Build surface as a spare or replacement for your 3D printer.

Cut to 235x235mm this will fit a wide variety of 3D Printers Including: Ender-3, Ender-3 Pro, Ender-3 V2, Ender-5, Ender-5 Pro, Ender-3 S1, Ender-3 S1 Pro, Ender-3 NEO, Ender-3 V2 Neo and many more.

Perfectly cut to 235 x 235mm to fit a wide variety of 3D Printers
Soft magnetic backing makes prints easy to remove

Quick heat up time compared to glass
Deep pores to aid adhesion

How to Install:

Remove the backing on Sheet B.
Stick this directly to your 3D Printers Heated Bed.
Place Sheet A on top. Accurate bed levelling and offset adjustment is important, so you don’t damage your build surface.
Do not use any tape, adhesive sprays, or liquids.
Clean your bed regularly by using a mild soapy water solution made with warm water.

In the Box

print surface (Sheet A) and the bottom magnetic layer (Sheet B).