Fast Charging Module PD/QC/AFC - TYPE-C

SKU:

19-00019862

In Stock

Ships in 24 Hours

€3⁹⁰

Our quantity discounts:

Quantity

10+

100+

Price

€3.12

€2.73

+ −

Ask a question

Availability in Retail Store

Payments & Shipping

DIY device that draws specified voltage from USB PD compatible AC adapter or power bank (You can also output it from a QC compatible charger using a Type-C cable. (5V/9V/12V/20V depends on the corresponding output voltage of the charger side.)
The switch on the board allows the output of DC5V/9V/12V/15V/20V, so there is no need to modify the settings such as soldered
Equipped with eMarker IC to output up to 100W (20V/5A)
5V output set at factory (All switches off)
Output pads are available for 2.54mm pitch header and 5mm pitch terminals
Depending on the lot, the board image and the way you set the switch may vary. (In that case, please refer to the back of the board)

Since there is no voltage indicator after adjusting the dip switch, use a multimeter to measure the voltage before connecting to the application circuit.
If the dip switch is not adjusted according to the table, the module will output any voltage of the above voltage.
When using, please check the operating voltage and polarity of the connected device.
Please read Depending on the device, it may cause damage or accidents.
We do not offer any warranty on damage to your device, accidents, or other damage.

Support induced: 5V, 9V, 12V, 15V, 20V voltage
Rated Current: 5A (max)
Fast charge support protocol: PD2.0/PD3.0, QC2.0/QC3.0, AFC
Support voltage: 5V, 9V, 12V, 15V, 20V (voltage step is not supported)
Voltage adjustment method: According to the table on the back of the board, adjust the DIP switch to control the voltage output
Input connector: USB Type C socket
Size: 31x20mm
Weight: 2.9g