Αρχική Σελίδα/Ρομποτική/Arduino/Πλακέτες Επέκτασης για Arduino/Motor Shield for Arduino - L293D

Motor Shield for Arduino - L293D

Κωδικός:

39-00010391

ΚατασκευαστήςOem

Διαθέσιμο

Αποστολή σε 24 ώρες

€4⁹⁰

Ποσοτικές εκπτώσεις:

Ποσότητα

10+

Τιμή

€3.92

+ −

Κάνε μια ερώτηση

Διαθεσιμότητα Καταστημάτων

Πληρωμή & Μεταφορικά

Περιγραφή
Χαρακτηριστικά

L293D is a monolithic integrated, high voltage, high current, 4-channel driver,you can use DC motors and power supplies of up to 36 Volts, the L293D chip is also known as a type of H-Bridge,which is typically an electrical circuit that enables a voltage to be applied across a load in either direction to an output, e.g. motor.

Compatible with the Arduino line of products.

2 interface for 5V Servo connected to the for Arduino's high-resolution dedicated timer - no jitter.
Can drive 4 DC motors or 2 stepper motors or 2 Servo.
Up to 4 bi-directional DC motors with individual 8-bit speed selection.
Up to 2 stepper motors (unipolar or bipolar) with single coil, double coil or interleaved stepping.
4 H-Bridges: per bridge provides 0.6A (1.2A peak current) with thermal protection, can run motors on 4.5V to 36V DC.
Pull down resistors keep motors disabled during power-up.
2 external terminal power interface, for seperate logic/motor supplies.
Tested compatible for Arduino Mega, Diecimila & Duemilanove.
Reset button.