Raspberry Pi Antenna KIT - CM4/CM5

06-00019905
SC0480
CompanyRaspberry Pi Part NumberSC0480
Upon Order
Available in 4-10 days
680
Gropbotronics Store Availability
Availability in Retail Store
Payments & Shipping

The official external antenna for your Compute Module 5 or 4

  • Frequency range: 2400-2500/5100-5800 MHz
  • Bandwidth: 100–700MHz
  • VSWR: ≤ 2.0
  • Gain: 2 dBi
  • Impedance: 50 ohm
  • Polarisation: Vertical
  • Radiation: Omnidirectional
  • Maximum power: 10W
  • Connector: SMA (female)
  • Antenna dimensions: 108 mm × 10 mm
  • Shell material: ABS
  • Installation: Screw
  • Operating Temperature: -35 to +75°C
  • Weight: ± 3 g

  • Connect the U.FL connector on the cable to the U.FL-compatible connector on Compute Module
  • Screw the toothed washer onto the SMA (male) connector on the cable, then insert this SMA connector through a hole (e.g. 6.4 mm) in the end-product mounting panel
  • Screw the SMA connector into place with the retaining hexagonal nut and washer
  • Screw the SMA (female) connector on the antenna onto the SMA (male) connector which now protrudes through the mounting panel
  • Adjust the antenna to its final position by turning it through up to 90°, as shown in the illustration below
  • To use the Antenna with your Compute Module, add a dtoverlay instruction in /boot/firmware/config.txt. Add the following line to the end of config.txt: dtparam=ant2

Warranty
12 Months Manufacturer Warranty
Company
Raspberry Pi
G. Weight
0.001kg
Find similar
  • We suggest also