Solar Battery Charger Regulator 10A - Dual USB

This series solar charge controller is a kind of intelligent, multi-functional solar charge and discharge controller. All the controlling parameters can be reset flexibly to satisfy your different needs. Solar controller has specifically designed to meet the needs of the rural electrification market. The low cost resulted from using the latest electronic technology and high volume manufacturing.

We are reputable trader of solar charge controllers,power inverters,and solar power systems. All our products are designed for high quality and high reliability. The controller has a low failure rate and will last a long time. The solar controllers are built-in electronic fused that do not require replacements. The solar controlers electronics are protected with moisture-tight coating, minimizing damage from humidity and from nesting insects. Solar controller is fully automatic and requires no adjustments or user selections.

• Visual LCD graphic symbol, brief key operation.
• Build-in industrial micro controller.
• Automatic identification system voltage level, intelligent PWM charge mode.
• Adjustable charge/discharge control parameters, settable operating modes of loads.
• Build-in short-circuit protections, open-circuit protections, reverse protections, over-load protections.
• Dual mosfet Reverse current protections ,low heat productions.　
• Over-load and short-circuit protection.
• With dual USB 5V output.

NOTES

• The function of the controller is to protect the voltage overshoot and discharge.
• When the battery voltage is too low, the controller to stop output; after the solar panels charging, the battery will return to 12.6 v. It is a natural to output.
• 12.6 v is to restore the discharge voltage.
• When the solar panels to recharge battery float charging voltage can be achieved. It will stop charging. This is called overshoot protection.
• After the battery discharge, the battery outside will flash, this is to remind the user, the configuration is not reasonable, it need to take battery connection.
• The controller normal voltage of 10.8 v to 13.7v. This two voltage fluctuation, you can be set manually.

Safety Instructions:

• Make sure your battery has enough voltage for the controller to recognize the battery type before first installation.
• The battery cable should be as short as possible to minimize loss.
• The regulator is only suitable for lead acid batteries: OPEN,AGM, GEL it is not suited for nickel metal hydride, lithium ions or other batteries.
• The charge regulator is only suitable for regulating solar modules. Never connect another charging source to the charge regulator.