Αρχική Σελίδα/Μηχανολογικά/Κινητήρες/Οδηγοί Κινητήρων/Stepper Motor Driver TMC2209 V2.0

Stepper Motor Driver TMC2209 V2.0

Κωδικός:

59-00012244

Part Number: TMC2209

ΚατασκευαστήςOem Part NumberTMC2209

Εξαντλημένο

€6⁸⁰

Ποσοτικές εκπτώσεις:

Ποσότητα

10+

Τιμή

€5.44

Κάνε μια ερώτηση

Διαθεσιμότητα Καταστημάτων

Πληρωμή & Μεταφορικά

Περιγραφή
Χαρακτηριστικά

TMC2209 have all function of TMC2208, can completely replace tmc2208. At the same time, TMC2209 have better heat dissipation, support bigger current, support sensorless-homing function.

Features:

Ultra quiet
Large heat sink,good heat dissipation
Support sensorless-homing function.
Support uart mode by set jumper caps instead of welding on mks gen_l V2.0,skr1.3/1.4,mks sgen_l.

NOTES

Pay attention to the connection direction,do not reverse it.
The motor direction is opposite to that of A4988 and DRV8825, please adjust the firmware or adjust the motor wiring if you want to change A4988.
Dir/step mode used in the printer control board, please pay attention to set the jumper cap MS1 MS2.

Default current: 0.88A
Recommend current: 1.72A (at most)
Max current: 2A
Logic voltage: 3.3V/5V
Input voltage: 5.5 - 28V

Microstep: Up to 1/256
Mode:
- DIR/STEP
- UART

Microstep set:

Microstep setting
M0	M1	STEP
GND	GND	8
VCC_IO	GND	32
GND	VCC_IO	64
VCC_IO	VCC_IO	16

Driver current regulation:

Verf measures the voltage of Gnd and potentiometer middle.
Please DO NOT connect the motors when measuring the voltage, or it's easy to burn the drive.
Please connect the power supply when measuring voltage as well, do not connect only the USB power.
Please pay special attention to the direction, do not insert wrongly!

Uart mode:

Uart mode can be used on mks gen_l(v2.x),mks sgen_l,skr1.3/1.4 by set jumper cap like below: