Σημαντική ενημέρωση: Προτείνουμε αλλαγή κωδικού για την ασφάλειά σας (οι κωδικοί χρησιμοποιούν πολύ ασφαλή μέθοδο κρυπτογράφησης)

Στις 22/5 σημειώθηκε μη εξουσιοδοτημένη πρόσβαση στο κατάστημά μας. Μάθετε περισσότερα εδώ.

Αρχική Σελίδα/Ρομποτική/Breakout Boards/Μετατροπείς Ρεύματος/DC-DC Automatic Step Up-down Power Module - 3.3V 600mA

DC-DC Automatic Step Up-down Power Module - 3.3V 600mA

Κωδικός:

25-00016907

Part Number: DFR0568

ΚατασκευαστήςDFRobot Part NumberDFR0568

Διαθέσιμο

Αποστολή σε 24 ώρες

€4⁸⁰

+ −

Κάνε μια ερώτηση

Διαθεσιμότητα Καταστημάτων

Πληρωμή & Μεταφορικά

Περιγραφή
Χαρακτηριστικά

This power module contains the function of automatic buck-boost and integrates with the related circuit of buck-boost converter. Its mini body is very easy for embedding.

Input voltage range 2.5-15V, fixed output voltage 3.3V, the maximum load current is 0.6A and its quiescent current is as low as 150uA. In theory, the work frequency of the module can reach to 1.2MHz. Besides, it has steady output voltage, which can work long time without voltage shift and is suitable for the occasions with high requirements. You can use this power module to DIY mobile power bank and provide constant power for your project.

Silkscreen “DM13B” and “DM14” are for Production Base Codes only. Both of them belong to V2.0, and they have no difference in performance.

Applications

Power supply for controller main-board, DIY current source, floodlight, DIY toy car, communication device, digital radio.

Note: The input voltage can not exceed 15V

Input Voltage: 2.5～15Vdc
Output Voltage: 3.3V
Output Accuracy: ±0.1V
The Maximum Output Peak Current: 600mA
Full-load Output Ripple: Vpp<50mV
No-load Current: IQ 150uA
Switch-off Function: Not Support
Operating Temperature: -40℃ ~ +85℃
Operating Humidity: 20% ~ 90% relative humidity, no condensation
Storage Temperature: -10℃ ~ +50℃
Installation Method: Chip-mounting
With or Without Isolation: Without Isolation
Service Life: 50000h
Dimension : 17×13mm

NOTES

The input voltage must within 15V.
Load current should not be in 600mA or above for a long time, otherwise it will affect the service life of the module and even burn out.
If the load current is relatively high, you should increase the minimum input voltage to ensure normal operation.