Αρχική Σελίδα/Ρομποτική/Breakout Boards/Μετατροπείς Ρεύματος/DC-DC Multi-output Buck Converter - 3.3V/5V/9V/12V

DC-DC Multi-output Buck Converter - 3.3V/5V/9V/12V, 2 image

DC-DC Multi-output Buck Converter - 3.3V/5V/9V/12V

Κωδικός:

25-00016906

Part Number: DFR1015

ΚατασκευαστήςDFRobot Part NumberDFR1015

Διαθέσιμο

Αποστολή σε 24 ώρες

€7⁴⁰

+ −

Κάνε μια ερώτηση

Διαθεσιμότητα Καταστημάτων

Πληρωμή & Μεταφορικά

Περιγραφή
Χαρακτηριστικά

Multiple-output DC-DC converters are essential in a multitude of applications where different DC output voltages are required. This DC-DC step-down voltage power module converts 7.5V~30V input to an output of 3.3V/5V/9V/12V (default to 5V), which can be selected by short-circuiting the corresponding pads on the back.

It withstands up to 5A load current with suitable heat dissipation (not included) and has 70℃ over-temperature and overload protections. Besides, there is an onboard LED indicator that shows a solid red light when everything works fine and goes out when the protection mechanism is triggered and the voltage automatically drops to 0.1V. The multi-voltage buck power module can be used in power control systems for LEDs, robots, drones, servos, low-power motors, and so on.

This module outputs 5V by default and the corresponding 5V solder pad is short-circuited. To output other voltages, for instance, 3.3V, please disconnect the 5V pad and short-circuit the 3.3V solder pad.

Since this is a step-down converter, the input voltage should be larger than the output, and it works better with a voltage difference of 2V and above.

Note: The output parameters are measured at 25 ℃, and the heat dissipation (heat sinks) is required for continuous large current load.

Technical data

Input Voltage: 7.5V~30V (Below 24V is recommended)
Rated Output Parameters (heat dissipation not required):
- 3.3V/0~3A, 5V/0~3A
- 9V/0~2.5A, 12V/0~3A
Maximum Output Parameters (heat dissipation required)
- 3.3V/5A (16.5W), 5V/5A (25W)
- 9V/3.5A (31.5W), 12V/3.5A (42W)
Low Ripple: 30mV
Soldering Hole Pitch: 2.54mm (can solder pin headers)
Dimensions: 2.7cm×2cm (length×width)