Αρχική Σελίδα/Ρομποτική/Αισθητήρες/Αερίων/Fermion MEMS Odor Smell Gas Detection Sensor (Breakout, 0.5-50ppm)

Fermion MEMS Odor Smell Gas Detection Sensor (Breakout, 0.5-50ppm)

Κωδικός:

25-00016709

Part Number: SEN0571

ΚατασκευαστήςDFRobot Part NumberSEN0571

Διαθέσιμο

Αποστολή σε 24 ώρες

€6²⁰

+ −

Κάνε μια ερώτηση

Διαθεσιμότητα Καταστημάτων

Πληρωμή & Μεταφορικά

Περιγραφή
Χαρακτηριστικά

Fermion: MEMS Odor Smell Gas Detection Sensor employs state-of-the-art microelectromechanical system (MEMS) technology, endowing the sensor with compact dimensions (13x13x2.5mm), low power consumption (＜20mA), minimal heat generation, short preheating time, and swift response recovery. The sensor can qualitatively measure odor gas concentration, suitable for breath detector, odor detection and other application scenarios.

The MEMS series currently encompasses 11 different types of gas sensors (HCHO, CO, CH4, VOC, NH3, H2S, EtOH, Smoke, Odor, H2, NO2), which can be combined as per specific requirements.

Precautions for use

Kindly remove the protective film before usage.
To prevent exposure to volatile silicon compounds vapors (such as silicone adhesive, hair gel, silicone rubber, or other locations where volatile silicon compounds are present).
Avoid exposure to high concentrations of corrosive gases (such as H2S, SOX, Cl2, HCl, etc.).
Prevent contamination from alkalis, alkali metal salts, and halogens.
Refrain from prolonged exposure to extreme environments (such as high temperatures, high humidity, high pollution).
Avoid contact with water, condensation, and freezing.
Minimize excessive vibration, impact, and dropping.
Please refrain from employing this module in systems that involve personal safety concerns.
For extended periods of non-usage, it is advisable to preheat the module for at least 24 hours.

Wiring Diagram of Fermion: MEMS Odor Sensor and Arduino UNO

Gas detected: H2S, EtOH, acetone, etc
Detection range: 0.5-50ppm
Operating voltage: 3.3-5V
Operating current: ＜20mA
Output signal: Analog voltage
Sensitivity: R0(in air)/Rs(in 5ppm H2S) ≥ 2
Operating temperature: -10-50℃
Operating humidity: 15-90%RH (non-condensing)
Lifespan: ≥5 years (in air)
Dimension：13×13 x 2.5mm/0.0.51×0.51x0.1"

Compact size, measuring only 13*13*2.5mm
Low power consumption, operating current ＜20mA
High sensitivity and rapid response recovery
Advanced MEMS technology

APPLICATIONS

Aviation safety: monitors the presence of hazardous gases or vapors in the aircraft cabin or cockpit.
Spoiled food material detection: evaluates the freshness and safety of food products by detecting the emission of odor compounds.
Body odor detection: analyzes the human body odor and provides feedback or suggestions for personal hygiene or health care.
Other health applications: diagnoses or monitors various health conditions by detecting the changes in breath or skin odor.