ΔΩΡΕΑΝ ΜΕΤΑΦΟΡΙΚΑ για παραγγελίες άνω των 85.00 έως 2kg

Adafruit Αισθητήρας Αφής 5-Pad (Capacitive) - AT42QT1070

από Adafruit
This breakout board is the simplest way to create a project with mutiple capacitive touch sensors.
09-00001362
Ογκομετρικό βάρος: 0kg
Εγγύηση: Ως εξάρτημα, δεν καλύπτεται
Κατασκευαστής: Adafruit
Χώρα Προέλευσης: ΗΠΑ
Διαθέσιμο
Αποστολή σε 24 ώρες
Χωρίς απόθεμα στο φυσικό κατάστημα
9.20
Χωρίς ΦΠΑ 7.42
+

ΠΕΡΙΓΡΑΦΗ

This breakout board is the simplest way to create a project with mutiple capacitive touch sensors. No microcontroller is required here - just power with 1.8 to 5.5VDC and connect up to 5 conductive pads to the 5 left-hand pins. When a capacitive load is detected (e.g. a person touches one of the conductive contacts) the corresponding LED on the right lights up and the output pin goes low. You can use this to update an existing normal-button project where buttons connect to ground when pressed. 
Comes with a fully assembled board, and a stick of 0.1" header so you can plug it into a breadboard. For contacts, we suggest using copper foil, then solder a wire that connects from the foil pad to the breakout.

ΧΑΡΑΚΤΗΡΙΣΤΙΚΑ

Εγγύηση:
Ως εξάρτημα, δεν καλύπτεται
Κατασκευαστής
:
Adafruit
Μικτό Βάρος:
0.001kg
Χώρα Προέλευσης:
ΗΠΑ
Τύπος Αισθητήρα:
  • Αφής
Τυπική Τάση Εισόδου:
  • 3.3VDC
  • 5VDC
Ρεύμα Λειτουργίας:
17uA
Διασύνδεση:
  • Ψηφιακή
Πρωτόκολλο Eπικοινωνίας:
  • Χωρίς

  • That only one contact will be detected at once (this is to protect against having a hand brush against two or more contacts at once). 
  • This board uses the chip in 'standalone' mode only, it cannot be used in I2C mode.

ΠΡΟΤΕΙΝΟΥΜΕ ΕΠΙΣΗΣ