+302118004320
English (GB)
0Cart

Standalone 5-Pad Capacitive Touch Sensor Breakout - AT42QT1070

09-00001362
CompanyAdafruit
Out of Stock
€920
Adafruit
Add to wish list
Ask a question
Gropbotronics Store Availability
Availability in Retail Store
Payments & Shipping

This breakout board is the simplest way to create a project with mutiple capacitive touch sensors. No microcontroller is required here - just power with 1.8 to 5.5VDC and connect up to 5 conductive pads to the 5 left-hand pins. When a capacitive load is detected (e.g. a person touches one of the conductive contacts) the corresponding LED on the right lights up and the output pin goes low. You can use this to update an existing normal-button project where buttons connect to ground when pressed. 
Comes with a fully assembled board, and a stick of 0.1" header so you can plug it into a breadboard. For contacts, we suggest using copper foil, then solder a wire that connects from the foil pad to the breakout.

Warranty
Δεν καλύπτεται με εγγύση απο τον Κατασκευαστή
Company
Adafruit
Gross Weight
0.001kg
Sensor Type
  • Capacitive
Typical Input Voltage
  • 3.3VDC
  • 5VDC
Oparating Current
17uA
Interface
  • Digital
Communication Protocol
  • Without
Find similar
  • We suggest also