+302118004320
English (GB)
0Cart

Stepper Motor - 0.35kg.cm 5V

19-00012858
CompanyOem
In Stock
Ships in 24 Hours
€250
Our quantity discounts:
Quantity
10+
100+
Price
€2.00
€1.75
+ −
Add to wish list
Ask a question
Gropbotronics Store Availability
Availability in Retail Store
Payments & Shipping

This is a great first stepper motor, good for small projects and experimenting with steppers. This uni-polar motor has a built in mounting plate with two mounting holes. There are only 8 steps per revolution, but inside is a 1/64 reduction gear set. What this means is that there are really 8*64 steps per revolution = 512 steps! The shaft is flattened so its easy to attach stuff to it with a set-screw. A perfect first stepper motor and works well with the Motor Shield for Arduino. 

The gearing has a few side effects which are important to note. First, you can turn the stepper by hand but not as smoothly as an un-geared stepper. It also means you shouldn't use interleaved or micro-stepping to control or it will take forever to turn. Instead use single or double stepping. The torque is fairly high but its slower than un-geared steppers - we maxed out at about 80 RPM by over-driving it a bit with 9VDC. 

To use with the Adafruit Motor Shield, connect red to ground (middle), orange and pink to one motor port (say M1) and blue and yellow to the other motor port (say M2). So in order, thats: orange - pink - red - blue - yellow. Then just use the example code that comes with the Adafruit Motor Shield library and set the constructor to AF_Stepper motor(512, motornum) and the speed at 5 RPM by calling motor.setSpeed(5). Otherwise, you can also wire it up with some transistors and use the Arduino Stepper library.

  • Rated voltage: 5VDC
  • Number of pole: 4
  • Speed variation ratio: 1/64
  • Stride angle: 5.625°/64
  • DC resistance: 200 Ohm±7% (25°C)
  • Idle in-traction frequency: >600Hz
  • Idle out-traction frequency: >1000Hz
  • In-traction Torque: 0.35 kg.cm (34.3mN.m)
  • Self-positioning Torque:  0.35 kg.cm (34.3mN.m)
  • Dimensions:
    • Diameter: 28mm 
    • Tall: 20mm
    • Shaft:
      • Length: 9mm
      • Diameter flattened: 5mm 
    • Cable: 23cm 
    • Weight: 37 g
Warranty
Δεν καλύπτεται με εγγύση απο τον Κατασκευαστή
Company
Oem
Gross Weight
0.04kg
Holding Torque
0.35 kg.cm
Rated Voltage
5 Volt
Find similar
  • We suggest also