FREE SHIPPING for orders over 85.00

Pimoroni Breakout - Air Quality, Temperature, Pressure, Humidity Sensor - BME680

The state-of-the-art BME680 breakout lets you measure temperature, pressure, humidity, and indoor air quality, and is Raspberry Pi and Arduino-compatible!...
13-00035719
Gross Weight: 0.01kg
Warranty: Δεν καλύπτεται με εγγύση απο τον Κατασκευαστή
Company: PIMORONI
Part Number: PIM357
Made in: UK
In Stock
Ships in 24 Hours
Low stock in store
24.80
Without VAT 20.00
+
WISHLIST COMPARE

DESCRIPTION

The state-of-the-art BME680 breakout lets you measure temperature, pressure, humidity, and indoor air quality, and is Raspberry Pi and Arduino-compatible!

Use this breakout to monitor every aspect of your indoor environment. Its gas resistance readings will react to changes in volatile organic compounds and can be combined with humidity readings to give a measure of indoor air quality.

Want to get an idea of whether there's adequate ventilation in your bedroom, your workshop, or workplace? Set up a BME680 on a Pi Zero W and have it log sensor readings to a file, or stream live data to a web service like adafruit.io or freeboard.io.

It's also compatible with our fancy new Breakout Garden, where using breakouts is as easy just popping it into one of the six slots and starting to grow your project, create, and code.

SPECIFICATIONS

Warranty:
Δεν καλύπτεται με εγγύση απο τον Κατασκευαστή
Company:
PIMORONI
Part Number:
PIM357
Gross Weight:
0.01kg
Made in:
UK
Sensor Type:
  • Barometric Pressure
  • Humidity
  • Temperature
Typical Input Voltage:
  • 3.3VDC
  • 5VDC
Interface:
  • Digital
Communication Protocol:
  • I2C

EXTRA SPECS

  • Bosch BME680 temperature, pressure, humidity, air quality sensor
  • I2C interface, with address select via ADDR solder bridge (0x76 or 0x77)
  • 3.3V or 5V compatible
  • Reverse polarity protection
  • Raspberry Pi-compatible pinout (pins 1, 3, 5, 7, 9)
  • Compatible with Raspberry Pi 3B+, 3, 2, B+, A+, Zero, and Zero W

  • In our testing, we've found that the sensor requires some burn-in time (at least 20 minutes) and that readings may take a couple of minutes to stabilise after beginning measurements
  • The solder pads (marked ADDR) can be bridged to change the I2C address from the default of 0x76 to 0x77, meaning that you can use up to two sensors on the same Raspberry Pi or Arduino