Το κατάστημα μας στην Αθήνα θα κλείσει σήμερα 6/12 στις 17:00 για λόγους ασφαλείας.

ΔΩΡΕΑΝ ΜΕΤΑΦΟΡΙΚΑ για παραγγελίες άνω των 85.00 έως 2kg

Kitronik Motor / Stepper Motor Drive Board

από Kitronik
This board has the ability to drive 2 DC motors or 1 stepper motor. Providing up to 2A peak per channel at 7V, it's great for bringing movement to your project.
83-00005108
Κατασκευαστής: Kitronik
Χώρα Προέλευσης: Ηνωμένο Βασίλειο
Διαθέσιμο
Αποστολή σε 24 ώρες
Χωρίς απόθεμα στο φυσικό κατάστημα
6.50
Χωρίς ΦΠΑ 5.24
+

ΠΕΡΙΓΡΑΦΗ

This board has the ability to drive 2 DC motors or 1 stepper motor. Providing up to 2A peak per channel at 7V, it's great for bringing movement to your project.

This circuit uses the DRV8833 and allows up to 2 DC motors or 1 stepper motor to be controlled by a microprocessor. This is useful as a microcontroller cannot, on its own, output enough power to drive most motors. Using this board you can control motor with digital outputs (two per motor) from your microcontroller while powering it separately from a suitable power source.The motor driver operates off a wide power supply (2.7-10.8V) and can provide up to 1.5A per output or 3A if the motor is connected to both outputs in parallel. Depending upon the state of the two control lines, the motor can be controlled to coast, reverse, go forward & brake.

The board can easily be connected to a microcontroller and will operate at 3V or 5V.

ΧΑΡΑΚΤΗΡΙΣΤΙΚΑ

Max. Current per Channel:
2A
Τύπος Οδηγού:
  • DC Motor
  • Stepper

ΕΠΙΠΛΕΟΝ ΧΑΡΑΚΤΗΡΙΣΤΙΚΑ

  • Drives two motors or one stepper motor
  • 1.5A per channel

ΔΥΝΑΤΟΤΗΤΕΣ

  • Robotics

Διαστάσεις

  • Length: 38mm
  • Width: 28mm
  • Height: 3mm

Συνδεσμολογία

  • Vcc: Supply Voltage (0-10.8V)
  • GND: Ground
  • nSLEEP: Sleep mode pin (Bringing this low enters the device into sleep mode)
  • xINx: Control, logic inputs (AIN1, AIN2, BIN1, BIN2)
  • xOUTx: Motor outputs (AOUT1, AOUT2, BOUT1, BOUT2)

Το Κιτ περιέχει

  • 1 x Motor/Stepper Driver Breakout Board